How to start the Soya protein Extruder

Start the pre-conditioner and feeder, turn on the oil pumper and main motor.

Adding the steam for the pre-conditioner for mixing, you could turn the steam a little bigger as the temperature of the pre-conditioner is lower at the beginning. Pls pay more attention to the content of water in the raw material,the raw material couldnot go into the inflating barrel if it contain too many water,

When the raw material come out from the Soya protein Extruder barrel normal and steady, growing the frequency of the feeder; when the soya powder spray out from the model and the temperature of the

When the extrudate had been steady, people need to use the above way to adjust the model position to the smallest position.

extrudate is higher enough, adjust the position of the model from more hole to the middle. Pls note that the adjustment need quickly and right.

According to the request for the cultivated degree of the extrudate to adjust the plug screw to the direction of the screw and fixation.

When the raw material normal and the quality of the extrudate arrive the request, install the cover for normal producing.

    Arrange different diameter more hole models and different diameter pressure ring,you could get different production capacity and different cultivated degree inflating soya.

【 Go Back 】 | 【 Print 】